I could'nt care less if they are in diferent subnets, but i already changed the m1 mask to 255.255.0.0/(router also) and had to reset it because he couldn't assign an ip to any device.so I assume, best case for me is a firmware that can do that out of the box.Īfter reading ALL this posts still not shure if I can flash my Soundmate M1 with Airmusic NW11 Firmware. All three devices need to see each other. So I want to stream music that is on my NAS, from the music player on my tablet. And why is this a big problem? Because ALL my music is in a XPEnolgy NAS on my network. I bought it thinking i could connect it to my home wifi and stream from any device on my network. Let me start by saying why the Soundmate M1 is not good enough for me.
#Soundmate connect to laptop windows 8.1
I have Windows 8.1 and I think it is a windows problem because IOS and Linux is working well. I can read files from the stick, but I cannot play from windows to the device. Option 'content_directories' '/tmp/mnt/disk-a1' Masterflac check the file /etc/config/ushare
#Soundmate connect to laptop how to
I'm using Windows, and i don't know how to code. I can't see it on my wireless list anymore. Īlso i want to ask, if is any chance to unbrick another airmusic NW11, which i upgraded the firmware and after one hour stops working. Can you tell me please which firmware version can see music from the memory stick ? I have FW: 1.1.01-A21(A.01). I have an airmusic NW11, and when i plug an memory stick into it, i can see on my phone (ShareOn Audio app), the folders, but i can't see the files inside folders. But in another post … 84#p167584 they use Putty, so it might also work with windows. In these posts they also used linux (command line "screen /dev/ttyUSB0 115200"). The above link refers back to the following two pages: … 15#p183315 and … 95#p149595. And finally you copy the data to you flash memory. Then you run a python script that just copies all the bytes to the router. In essence one opens the router with a screen command, kills the screen, but the router is already connected. I checked my previous post it says:Ī python script that can use mw within the u-boot software. If I remember well I had to use a telnet session in linux which I could keep open and then run the python script.
0 kommentar(er)
